socket 1 การใช้

• It was an updated Socket 1 with added support for Pentium OverDrive processors.
• ODP chips will not work in Pre-Socket 1 486 boards due to the extra pin.
• Socket 1 was intended as a 486 upgrade socket, and added one extra pin to prevent upgrade chips from being inserted incorrectly.
• "' Socket 1 "'was the second of a series of standard CPU sockets created by Intel into which various x86 microprocessors were inserted.
• Socket 1 was a 169-pin low insertion force ( LIF ) 17?7 pin grid array ( PGA ) socket suitable for the 5-volt, 16 to 33 MHz 486 SX, 486 DX, 486 DX2 and 486 OverDrive processors.
• The chip will actually physically fit into an older 486 socket such as a socket 1 or 2 or the original 168-pin 80486 socket, but doing this requires a replacement voltage regulator, since the AMD chip runs at 3.45 volts.
• And in my case would game ( FPS ) performance degrade if I was using cpu socket 1 to run the game ( the 2050 ) and my graphics card was connected to the 2200 and affinity for all other processes was set to socket 0 . ( Changeable by me)
• The ODPR chips had 168 pins and functioned as complete swap-out replacements for existing chips, whereas the ODP chips had an extra 169th pin, and were used for inserting into a special'Overdrive'( Socket 1 ) socket on some 486 boards, which would disable the existing CPU without needing to remove it ( in case that the existing CPU is surface mounted ).
• It describes the sutaris as 3 / 4 inch long and weighing 1.5 to 2 grains, varying in color from dirty white to black, and describes the handle as 3 to 3.5 inches long and frequently made from two joints of bamboo wood, with sockets 1 / 4 to 3 / 8 inch deep and with the cavity exposed at one end for storage of additional sutaris.